NOTE: Heatsink styles may vary.
CAUTION: Do not over-tighten fasteners.
 
Install Processor Heatsink(s)
A. Remove the protective film on the TIM if present.
B. Align heatsink fins to the front and back of the chassis for correct airflow. Airflow goes from front-to-back of chassis. Each heatsink has four captive fasteners and should be tightened in a diagonal manner using the following procedure:
C. Using a #2 Phillips* screwdriver, start with screw 1 and engage screw threads by giving it two rotations and stop. (Do not fully tighten.)
D. Proceed to screw 2 and engage screw threads by giving it two rotations and stop. Similarly, engage screws 3 and 4.
E. Repeat steps C and D by giving each screw two rotations each time until each screw is lightly tightened up to a maximum of 8 inch-lbs torque.
 
 
Above contents from below linked PDF, page 4

Movies

SlokySTEP, smart torque everywhere possible

Files Download

Sloky Torque_Screwdriver_Cat04_English.pdf

下载

Sloky Jimmore 3 steps to find your torque screwdriver.pdf

下载

Products

C4精密8mm扭力套筒

TSD-12-08

We invented mini adapter from 0.1~0.7Nm for professional players. Possible application includeing cell phones, laptops, drown, camera, watches and all kinds of 3C devices. Please contact with us if you want...

细节

20mm大扭力套筒

TSD-12-20

This is a brand new concept of big torque adapter from 6~18Nm which is never been done before. We believe it could be used for auto, motocycle and other heavy torque control application. Our torque adapter...

细节